tl;dr: Instructions to run (and calibrate!) a linear delta 3D printer on MachineKit. I use a CRAMPS board but much of this applies to other boards too.
The first post in this series showed how to get a CRAMPS board up and running with MachineKit, along with how to verify that each board feature works as expected.
This second post shows how to get a Linear Delta 3D printer (a la Rostock, Kossel, 3DR, Wolfstock, etc.) running and calibrated with this same CRAMPS/MachineKit combination. Most of the instructions will apply equally to other boards like the BeBoPr.